Version 2 (modified by 11 years ago) ( diff ) | ,
---|
Configure HP Procurve 2824 (J4903A)
We have a HP Procurve 2824 switch at both Telehouse and XO. We have the manual available.
Start by resetting to factory defaults.
Do that by poking a staple in both the reset and clear buttons and then releasing the reset button and keeping the clear button pressed. That may leave the switch in a state with all lights on. If so try unplugging and plugging it back in.
Next, try to access it via the serial console at 2400 baud.
- Set the system contact, password, and IP configuration
- Type: setup
- Set system contact to:
info@mayfirst.org
- Enter Manager password - cannot be more than 16 characters!
- Set the serial console
# configure # console baud-rate 115200 Command will take effect after saving configuration and reboot. # write mem # boot
After it restarts, you should re-connect via the new serial console settings
- At this point, you might want to upgrade the firmware. Check the HP page for the latest firmware. Check the running firmware with:
show version
- Set the hostname
hostname cafiero
Attachments (1)
- 2600-2800-4100-6108-MgmtConfig-Oct2005-59906023.pdf (5.2 MB ) - added by 8 years ago.
Note:
See TracWiki
for help on using the wiki.